I don't know what you're shooting at, but for some bench and offhand plinking and varminting,
I did a bit of an experiment with V-Max 110gr for a reduced recoil load.
I didn't get the recoil down as low as I would have hoped, for consistent velocity and accuracy, but it was less than the 155gr MK's that I was shooting.
I use only H4895 in my Sako 75 Stainless/Synthetic sporter bolt, 1:11" twist, 22" sporter factory barrel
with Lapua brass and Federal primers.
I was very pleased with the results,
have a look at some of the results below.
Didn't shoot many, because of the cost. (I have to watch my pension pennies !)
Also going to try some lead cast, with 60% H4895, and also some even lower velocity700x loads (but haven't got around to it yet !)