Author Topic: two piece locking bolt  (Read 337 times)

0 Members and 1 Guest are viewing this topic.

Offline Dirty Tiger

  • Trade Count: (10)
  • Avid Poster
  • **
  • Posts: 116
two piece locking bolt
« on: May 07, 2011, 08:17:25 pm »
I recently picked up a   22 match barrel that was really hard to open on my early model contender frame. I lightly stoned the bolts and it still wouldn't open the way it should. I have a 45/410 barrel that I rarely shoot so I swapped out the bolts in  the two barrels. The match 22 works fine now, but the last time iI fired the 45/410 barrel it opened after firing without pulling the trigger guard spur. Does that indicate not enough engagement with the locking bolt? It seems the new regime over at TC is a little less cooperative when it comes to sending out free replacement parts, so I thought it might be good to try to remedy this one one my own. Any suggestions?
                     






d

Graybeard Outdoors

two piece locking bolt
« on: May 07, 2011, 08:17:25 pm »
 

Offline DEACONLLB

  • GBO Supporter
  • Trade Count: (148)
  • Senior Member
  • *****
  • Posts: 1949
  • Gender: Male
Re: two piece locking bolt
« Reply #1 on: May 08, 2011, 07:04:07 am »
I think that is your problem. Put a little blacking from a felt marker on the bolt and close it a couple of times and you will be able to see how far the bolt is seating.
Deaconllb
Korean vet. NRA Member
Fourth fighter wing Kimpo Korea 1952 Fourth but first, the mig killers.
533rd material ,air defence Oxnard AFB 1953-1955
Pastor of the  CBCG-Fellowship group Tulsa Oklahoma.

 

go2gbo.com Webutation