Graybeard Outdoors banner
1 - 6 of 6 Posts

·
Registered
Joined
·
35 Posts
I have the Brownchester saddle ring carbine. The rear sight doesn't have a way to adjust for vertical sighting except for the flip up ladder. My loads print about 6-7 inches low at 100 yds. Is there any way to adjust the rear sight other than use the flip up ladder? Presently I have a piece of brass wedged unter the sight to give a proper zero with the rear sight at 100 yds for hunting purposes.. However, I can't use the ladder sight at all now.
 

·
Registered
Joined
·
134 Posts
The sights on Winchester carbines leave a lot to be desired. I have no experience with the late model Browning guns, but, I replaced the rear sight on my original '86 SRC with a Marble's flip up. I did the same with the 1892s, also. It worked for me.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top