Graybeard Outdoors banner

1 - 7 of 7 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1



this is a p17 enfield Winchester, rear mount looks the same as the front only shorter.
 

·
Registered
Joined
·
108 Posts
Too much light to see but is it a dovetail ? If yes,measure it and if 19.5mm wide, it is an old type of mounting used in Europe.

See:
 

·
Registered
Joined
·
9,618 Posts
They look homemade. Or gunsmith made in a shop. Not mas produced. If homemade offends, then they look custom. Have you removed them to see if there are any marks on the under side?
 

·
Registered
Joined
·
13 Posts
Discussion Starter #5
I don't think they are custom as they have numbers stamped in them, the front is a #13 and the rear is a #7.
 

·
Premium Member
Joined
·
5,238 Posts
How do the rings attach? Weaver made a mounting system fr a while that used opposing screws. The rings fitted in a hole and the shank was dimpled for the set screws from the side. It's also possible its a Leupold gunsmith base. They were made(may still be???) for different rifles but were left blank for custom installations by a gunsmith./.
 
1 - 7 of 7 Posts
Top