Graybeard Outdoors banner
1 - 1 of 1 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
Just got back from the range with my 44 mag encore it wears a 12 in. tube
the load is rem case 26 gr. of H-110 fed mag primer topped with a 210 gr
win silver tip hp did not run them over a chron but when looking at the cases found the cases still had some crimp to them and a bullet would not fit in the fired case found a lot of powder burn on the case and under the scope primers look good no sign of pressure been loading for some time know never ran into this before cases are nickel plated groups were good it was about 20 degrees just had to go shoot and smell the powder in the air. Is there a problem with this load any ideas out there any input will help thks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top