Graybeard Outdoors banner
1 - 3 of 3 Posts

· Registered
Joined
·
203 Posts
Discussion Starter · #1 ·
Hi guys,

thanks for all the feedback on my last post. My question now is how do you know when the right amount of crimp is aquired? Right now, I am crimping my 9mm cartridges so that there is a shiny ring of shaved metal around the mouth of the case? Is this to much? Any suggestions would be greatly appreciated!

thanks,
Preston
 

· Registered
Joined
·
7,159 Posts
Don't experiment! Look for the measurement of the recommended diameter of the brass at the case mouth after your bullet is seated. I don't know the diameter for 9mm, but you should find out before continuing.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top