Graybeard Outdoors banner

federal brass wont take primer

1366 Views 3 Replies 4 Participants Last post by  John Y Cannuck
federal brass wont take primer

with the year 98 indicated could this be military brass? You can tell by looking at the base around the primer hole. It will have a line around it (crimp). It is my undestanding that this is to keep the primer from backing out when the ammo is used on a full auto weapon.

If this is the case you can get a crimp remover, some work in the press and re-swage the primer pocket. Others work like a chamfering tool and cuts it out. The later is easier to use.

Not sure if this is the problem but it sounds like it..

DonT
1 - 4 of 4 Posts
federal brass wont take primer

You have crimped military brass...clean up the primer pockets.
federal brass wont take primer

I got a primmer swagging tool from Dillion it works pretty slick
federal brass wont take primer

As a quickie, to try a few, your chamfer tool fill do a fair job taking off those crimps
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top