Graybeard Outdoors banner

1 - 2 of 2 Posts

·
Registered
Joined
·
282 Posts
Discussion Starter #1
I have a mauser action I am going to use on a project and the action had been badly pitted. Since I am working this into a 45acp rifle I am not concerned with strength the pits are not a structural concern.

I have ground out some but was wondering if anyone has used anything to "fill" these in the past? I am going to duracoat the action and barrel so I am not concerned with not being a able to blue it. Any thoughts??

DonT
 

·
Premium Member
Joined
·
5,238 Posts
The trick will be to get the rust stopped before filling. If not it will continue rusting and anything put in there will fail. You might try Actaglass..
 
1 - 2 of 2 Posts
Top