Graybeard Outdoors banner
1 - 3 of 3 Posts

·
Registered
Joined
·
69 Posts
Discussion Starter · #1 ·
Zachary, reference my post regarding moly coated bullets, you asked me if I was able to remove all of the moly. Please go to that post and read my reply. Also, I would like your input on the factory coatings, and any ideas on removing all traces of moly w/o harming my barrel.

Thanks for your time. Rojo
 

·
Premium Member
Joined
·
3,717 Posts
John,

From what I have learned throughout the years from competent gunsmiths, it is virtually impossible to remove "all traces" of moly from the inside of a barrel. Of course the more shots that are passed through, the more difficult it is to clean.

As for what solvents to use, I'm really not certain because I never use such solvents. You may, however, wish to contact the people at Jarrett rifles, and also Hill Country Rifles. They may tell you their experiences with moly coated bullets in general, and what solvents to use in specific.

Zachary
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top