Graybeard Outdoors banner
1 - 10 of 10 Posts

·
Registered
Joined
·
2,560 Posts
The short replay is yes. H&R will put the .357 and .44 mags on the SB1 frames. 44 Man
 

·
Premium Member
Joined
·
16,611 Posts
YUP!!

I just refit one to my 32-20 barrel myself!! Its just fine for lo pressure rounds too!!

CW
 

·
Premium Member
Joined
·
7,574 Posts

·
Premium Member
Joined
·
459 Posts
cwlongshot said:
YUP!!

I just refit one to my 32-20 barrel myself!! Its just fine for lo pressure rounds too!!

CW
So would a 45 LC be considered low pressure? I'd like to have a 45 LC barrel on my SB1.

LM
 

·
Registered
Joined
·
192 Posts
I would think it would be considered low pressure. If you look at the load data, even the hottest 45LC loads are lower in pressure than .357 loads. Factory 45LC loads would be substantially lower than that.
 

·
Registered
Joined
·
44,135 Posts
Discussion Starter · #8 ·
Thanks guys.. Billy; I don't have a 12 ga on hand, but I do have a 20..anything available for that? Of course, I may do better just swapping my 20 for a .357.
 

·
Premium Member
Joined
·
16,611 Posts
Lazermule said:
cwlongshot said:
YUP!!

I just refit one to my 32-20 barrel myself!! Its just fine for lo pressure rounds too!!

CW
So would a 45 LC be considered low pressure? I'd like to have a 45 LC barrel on my SB1.

LM
I feel this would also be just fine.

Current 357 and 44Mags come on this receiver. Just as a comparison, many of the heavier 45colt loads do not equal the 44 mags pressures. Personally, I would limit loads to "Ruger" levels.

CW
 
1 - 10 of 10 Posts
Top