Graybeard Outdoors banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello:

I need to know the proper specs in inch pounds for the action screws on a Remington 700 and Savage 10FP when torquing a McMillan A2 Tactical stock in place. The stock is not glassed or pillar bedded. Also, if there is a proper sequence for the front and rear screws.


Thank you,
 

·
Premium Member
Joined
·
5,238 Posts
I would contact McMillan for their input.. I usually don't bother torgueing action screws. I just put the front scerw down first the rear screw last just snug and if there should be a middle screwjust make it barely finger tight.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top