Graybeard Outdoors banner

1 - 6 of 6 Posts

·
Registered
Joined
·
1,594 Posts
Discussion Starter #1
Anyone know a source for a Ruger 10/22 standard Break-Down Guide for cleaning and repairs? I have a slide release that's hanging up also (right from the factory). Can you help me to figure out the problem and fix? TIA.


savageT
 

·
Registered
Joined
·
3,161 Posts
10-22 guide

savage t Steves page 7a I believe it was had a breakdown of the ruger 10-22 I have it on my favorites list but dont know enough about these things to transfer it to you. Go back to the old forum and get the address of Stevce off the reloading forum if you can and maybe you can get it from there hope that helps. :D JIM
 

·
Registered
Joined
·
3,161 Posts
10-22 breakdown

savage T try this http//stevespages.com/page7a.htm good luck :D JIM
 

·
Registered
Joined
·
1,594 Posts
Discussion Starter #4
Re: 10-22 breakdown

jhm said:
savage T try this http//stevespages.com/page7a.htm good luck :D JIM
Thanks Jim....Downloaded the print!

savageT
 

·
Registered
Joined
·
344 Posts
1st 10/22??

SAVAGET: Is this your first 10/22? If not, please ignore this if you already know it.

The slide release is MEANT to be released by hand. It will not release on it's own by pulling the charging handle back. It is a TWO HANDED affair to begin with.

They designed it with an upside down V to ride on. You can buy a replacesment stop or simply take and make that upside down V into a TRIANGLE.

There are sights with pics of the mechanism. I'd try asking at http://www.rimfirecentral.com or http://www.rugerforum.com/cgi-bin/cgiwrap/rugerforum/Ultimate.cgi?action=intro

Good luck!
 

·
Registered
Joined
·
1,594 Posts
Discussion Starter #6
Plainsman,

Thanks. I did know that you have to pull the slide back, then push sortof up and back on the release. Trouble is, I try and try and when I'm 'bout ready to heave it.....it releases!?????I've got the damn thing in the gunsmith waiting for him to work on it.



savageT
 
1 - 6 of 6 Posts
Top