Graybeard Outdoors banner
1 - 3 of 3 Posts

·
Registered
Joined
·
38 Posts
Discussion Starter · #1 ·
I have an old Ruger old army that was taken in trade by a dealer .It is out of time. I just got a manual from Ruger. Do you think I should try to dis/reassemble this or just take it to a 'smith? ROB
 

·
Registered
Joined
·
557 Posts
Rob

That totally depends on how handy you are, how good your visual memory is, and if you have done this before. If you haven't delved into the guts of a single action before, I'd suggest a gunsmith. Especially if you know one well enough that he'll let you look ovr his shoulder while he does it and explains the process.

Rugers are not overly complex, the springs are coil springs, and there are no real suprises in there, but if you haven't done it before, I wouldn't start on a timing job.

Just my $.02, and worth about that!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top