Graybeard Outdoors banner

1 - 3 of 3 Posts

·
Registered
Joined
·
124 Posts
Discussion Starter #1
Please excuse my deliberately misplaced post. I know no better quick-resource than our very own Quick so here goes. Not directly a Handi question but I'll make it one.

Of the many Handi's that have been scoped have you found that the allen screws are standerized. Need an allen spec on a .75" B-Square ring. I want to fabricate a "poor-mans" quick release lever. The first piece of data is the thread size and then maybe weld a small piece of metal to the screw like a sort of custom, angled lever, a small integral tool really. It'll be a flashlight mount.
 

·
Registered
Joined
·
124 Posts
Discussion Starter #3
I meant to say the screw that tightens the ring to its rail. All rings have set screws in the bottom to generate tension against their rails/bases. I'll be in touch with them of course. THNX for the link. All of my rings(3 pr.) share the same allen in the base but not the ring caps. Go figure.
 
1 - 3 of 3 Posts
Top