Graybeard Outdoors banner
1 - 10 of 10 Posts

·
Premium Member
Joined
·
1,471 Posts
Discussion Starter · #1 ·
So I bought a new 357 with a sb1. I used that receiver for a 20 gauge ush barrel. The fire pine strikes are extremely light and the shells won't fire. The barrel fitting is good. I noticed that the pin viewed when the action is open and hammer let down slow doesn't come out as far as others I have. Where can I send it?
 

·
Registered
Joined
·
12,510 Posts
if you don't want to mess with it
brian56 is supposed to be in that
business in the future, but i dont
know a timeline. you might shoot
him or tim a p.m.
 

·
Super Moderator
Joined
·
51,491 Posts

·
Registered
Joined
·
12,510 Posts
there's quite a bit in the f.a.q.'s that should show
you about anything you'd want to know if you
want to take it on yourself.
i would get a wolff spring to install in place of the
factory spring in addition to whatever else you
may need or want to do. i learned my lesson on that. . :(
 

·
Premium Member
Joined
·
1,471 Posts
Discussion Starter · #9 ·
That was about as easy as it could get. Took a file to the hammer a bit at a time until pin was at.o45 when trigger pulled. Cut open a she'll removed powder and pellets and loaded it. Pulled the trigger and bang off the primer went. Much better primer strike and not to deep either. Hope it works that well at the range. Thanks tim
 
1 - 10 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top