Graybeard Outdoors banner
1 - 2 of 2 Posts

·
Registered
Joined
·
139 Posts
Discussion Starter · #1 ·
I'm looking to recduce the length of pull on my 0/u shotgun bu 1/2 " or so. There is nobody around that can cut the stock in short time and I'm still shooting it weekly. I don't really want to do it myself unless I have to. It currently has a factory recoil pad that is 7/8" thick. Can anyone suggest a thinner recoil pad ? I'm thinking if I can fid something made out of a more modern material but only 3/8-1/2" or so, it might be just enough.

BTW Existing pad is 5.25x1.875"x.875 and curved.
 

·
Registered
Joined
·
64 Posts
You can go with a KICK-EZZ pad 1/2", slightly warm pad to form to the curve of the stock and grind to fit, watch your heel and toe, this will shorten your L.O.P., AND ONLY TAKE UP YOUR TIME AT THE BENCH.
GOOD LUCK.

RON KONTOWSKY
ACTIONS BY R.A.K.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top