Graybeard Outdoors banner

1 - 5 of 5 Posts

·
Registered
Joined
·
52 Posts
Discussion Starter #1
has anyone ever used small base dies for reloading.to see if that would help with sticking problems in there handi.
 

·
Super Moderator
Joined
·
51,142 Posts
Sticking problems can be eliminated by polishing the chamber, making sure the brass and chamber are clean and dry, and not shooting loads that are too hot. Read the ejector info in the FAQs and Help sticky, and welcome aboard. ;)

Tim
 

·
Registered
Joined
·
52 Posts
Discussion Starter #3
the other reason i was asking.every so often i will have a round (reload)that will not fully chamber.full length sized.still likes about 1/6in.from fully chambering.of course it will stick.have done all of that. and thank you
 

·
Premium Member
Joined
·
386 Posts
I use small base X dies for my semi-auto's not NEF's. You need to check your brass trim length and perhaps adjust your resizing die a touch to get proper sizing.
 
1 - 5 of 5 Posts
Top