Graybeard Outdoors banner

1 - 2 of 2 Posts

·
Registered
Joined
·
191 Posts
Discussion Starter #1
Hey machinist's and/or T/C 'smith's-

Where can I find the special "flat" washers used on the grip/stock screws? They have the standard ID for 1/4" bolts but the OD is ~.500" and they are ~.065" thick. I looked in a McMaster catalog but I wasn't sure what I was looking for - are they specifically made for T/C use or can I find them thru a merchandise supplier? Thanks!
 

·
Premium Member
Joined
·
5,238 Posts
I think I'd just give TC's service folks a call. They've been pretty good to deal with before and are usually out to please. One could likely make a washer to fit, but why bother..?
 
1 - 2 of 2 Posts
Top