Graybeard Outdoors banner

1 - 5 of 5 Posts

·
Registered
Joined
·
4,992 Posts
Discussion Starter #1
Has anyone out there have or used the Tasco Optima dot sight? I just put one on layaway at my gun shot it was a demo model and since Tasco went out of business they put it on clearance for 40 bucks. I snapped it up for that price as I know they were around $275.00 new when they first came out then I think they lowered the price to around $175.00 I will pick it up on Tue. or Wed. I want to put it on my Ballester Molina. I might have to modify a 1911 base to make it fit but for 40 bucks I am not complaining and since I know they went out of business if it goes bad at least I bought it with eyes open and did not take a hit like the guys that might have bought one at the regular price. Jim
 

·
Registered
Joined
·
16 Posts
Had one. Swapped it off to a friend. Got it back later in another swap deal. I think I paid a little less than $150 a few years ago. Liked it then, like it now. Goes on anything. Presently sitting on a Marlin 444P. Works good (and if that recoil doesn't hurt it, nothin' will). I've had it on a Glock, 10/22 Ruger, and want to try it on a dove gun next. You gotta' good deal. Good luck
 

·
Registered
Joined
·
381 Posts
Tasco Optima

I have one on a .38 Special conversion on the 1911 frame. The sight is light enough to still have the slide cycle reliably. I believe Midway had some bases on closeout.
 

·
Registered
Joined
·
198 Posts
Optima

Hi,
I have one on a Springfield V16. It works perfectly. Wish I could find another one!
 

·
Registered
Joined
·
4,992 Posts
Discussion Starter #5
Sweet guest!! I guess I got a good deal a 40 bucks!! I bought a colt 1911 base for 7.99 and 9.99 for shipping so it was 18.00 bucks for a base so I figure I have 60 bucks in it total not too bad I figure. Jim
 
1 - 5 of 5 Posts
Top